| 原文 | 译文 | 详情 |
|---|---|---|
| 浇道 | gate tunnel | - |
| 连接点 | connection point | - |
| 浇口 | ingate | - |
| 浇口 | sprue | - |
| 紧固板 | clambing platte | - |
| 喷射 | ejector | - |
| 喷射针 | ejector pin | - |
| 机器配置 | machine layout | - |
| 软盘驱动器 | floppy disk drive | - |
| 延时反馈 | delayed feed | - |
| 注射量 | shot volume | - |
| 喷嘴孔 | nozzle bore | - |
| 喷嘴工具 | nozzle tool | - |
| 缩小标记 | shrink mark | - |
| 注射压力 | injection pressure | - |
| 脱模 | demolding | - |
| 排气孔 | air vent | - |
| 着色剂 | colorant | - |
| 固定连接 | fixed gate connection | - |
| 硬磁盘 | hard disk | - |
| 润滑脂 | grease | - |
| 螺纹 | thread | - |
| 热流道 | hot runner | - |
| 加热圈 | heating tape | - |
| 绝缘板 | insulating plate | - |
| 抽芯机构 | core puller | - |
| 芯拔管 | core puller hose | - |
| 起重机 | crane | - |
| 球栅 | Ball grid | - |
| 连接器 | connector | - |
| 垫料 | melt cushion | - |
| 保压 | hold pressure | - |
| 保压时间 | hold pressure time | - |
| 尺寸检查 | dimensional check | - |
| 腔 | cavity | - |
| 质量控制 | quality control | - |
| 卷帘门 | rolling doors | - |
| 防逆流环 | backflow barrier | - |
| 滑块 | slider feed | - |
| 熔体 | melt | - |
| 螺杆 | screw | - |
| 螺栓 | bolt | - |
| 螺杆驱动 | screw driver | - |
| 传感器 | sensor | - |
| 紧固系统 | clambing system | - |
| 背压 | back pressure | - |
| 零件重量 | parts by wight | - |
| 温度测试仪 | temperature measuring device | - |
| 温度控制装置 | Temperature control unit | - |
| 分型线 | parting line | - |
| 切换点 | switchover point | - |
| 翘曲变形 | warpage | - |
| 水软管 | water hose | - |
| 模具保护时间 | Tool protection time | - |
| 模具紧固力 | mold clambing force | - |
| 钳 | nipper | - |
| 周期时间 | cycle time | - |
收藏成功
(推荐电脑端登录)
右上角查看我的术语->我的标签
